AEG BD431PB Notice D'utilisation page 40

5. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
6. Put the door with the outer side down on
a soft cloth on a stable surface.
7. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
8. Pull the door trim to the front to remove it.
9. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
10. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate or operate the appliance.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
40 ENGLISH
on the top edge of
1
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
11.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Top lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Check if...
The appliance is correctly connected to an electrical
supply.
The automatic switch-off is deactivated.
The appliance door is closed.
The fuse is not blown.