Publicité
Adjust the panel to achieve the required spacing, or to align.
IMPORTANT:
If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
m_
Slide the panel from side to side in the keyhole slot.
installed. Follow the instructions specific to your door panel
m
Use an hex key to raise or lower the adjustment pins
design.
which allows the door panel to swivel.
Tools Needed: %2" hex key
Door Panels - Custom Wood, Stainless Steel and
Oiled Bronze Designs
1.
Locate the holes in the door panels where the handle
mounting studs are to be installed.
2.
Fasten the handle mounting studs to the door panels.
3.
Install the handles to the handle mounting studs and tighten
the setscrews.
A. Door panel
C. Adjustment pins
Door Panels - Floating Glass Design
B. Mounting bracket
IMPORTANT: To align the handle correctly on the door, the plastic
Predrill a %" deep pilot hole the door panel through the open
handle spacer and the setscrews on the door handle must be in
holes in both the bottom and top hinges.
the positions designated in the chart.
Using slotted hex head screws (provided with refrigerator),
1.
Locate the holes in the door panels where the handle
attach the top and bottom hinges to the door panels. Fully
mounting studs are to be installed.
tighten all door panel screws.
2.
Insert the circular post on the back of the handle spacers into
the holes in the door panels.
A
B
—
TTT
o
Q
o
°
/
7
[
D
A. Plastic handle spacer
.
B. Straight handle mounting posts
A. Top hinge
C. Holes for screws
:
B. Mounting bracket
D. Adjustment pins
C. Curved handle mounting posts
D. Circular post
Using slotted hex head screws (provided with refrigerator) for
.
.
each side, attach the door panels to the hinge-side door trims.
3.
Depending on the compartment, rotate the plastic spacer so
.
-
:
.
:
that the curved handle mounting posts are either at the top or
Using Phillips head flat screws (provided with refrigerator),
bottom. See following chart.
install the handle side door trim.
Completely
tighten the screws attaching
the mountin
Freezer
_Refrigerator
brackets. Iocated at the bottom of the doors, to the overlay
Left-Hand Door
Right-Hand Door
panels.
Curved
Bottom
Top
Reinstall the top door trim and hinge cover.
Mounting Post
Snap the adjustment pin cover (provided with refrigerator) into
Setscrews
Right
Left
place.
4.
Slide the screw into the handle mounting stud. Insert the
screw assembly into the center hole of the plastic spacer and
fasten it to the door panel.
5.
Install the handles to the handle mounting studs so that the
setscrews are on the designated side and tighten the
setscrews.
23
Publicité
