Basic Installation For 2 Houses Or Flats; Installation Standard Pour 2 Logements - Alcad TCB-011 Manuel D'installation

V I D E O P O R T E R O E L E C T R Ó N I C O - V I D E O D O O R E N T R Y S Y S T E M S - V I D É O P O R T I E R É L E C T R O N I Q U E
I N S TA L A C I Ó N B Á S I C A 2 V I V I E N D A S

BASIC INSTALLATION FOR 2 HOUSES OR FLATS

INSTALLATION STANDARD POUR 2 LOGEMENTS

ESQUEMA UNIFILAR - SINGLE-WIRED DIAGRAM - SCHÉMA À UN FIL
SECTION TABLE
Up to 25 m -
Up to 100 m -
Use separate cable hose.
Section according to the number of monitors/telephones in the dwelling.
Funcionamiento - Operation - Fonctionnement
Nota:
SYSTEM ON STAND-BY
The functions of door opening and of communication with the entrance panel are disabled. It is possible to activate the monitor's
automatic switch-on system always providing that the system is not engaged
Maximum time of automatic switch-on: 30 seconds without the receiver being picked up. Once the comunication with entrance panel
has been established: 60 seconds.
SYSTEM ACTIVATED. MAKING A CALL
Only the monitor or monitors/telephones associated to the pushbutton will receive the call. Acoustic confirmation for the visitor. If the
handset of the monitor/telephone is picked up in another flat, there will be no communication and, in the case of monitors, automatic
switch-on will not be possible.
Time setting to answer: 30 seconds.
Maximum time setting for conversation: 60 seconds. Extension of time for conversation: + 60 seconds.
Note: For the automatic switch-on system to work correctly, the J1 jumper must be inserted. (See wired diagram page 15).
Note:
W