Installation - Alcad 905-PC Serie Mode D'emploi

2.1 Description of the power supply unit
1- Connecting the earth
2- Indicator that equipment is functioning correctly
3- Power supply control output connector
4- Fuse
5- Mains supply connection cable
6- Power supply control cable
7- Technical datasheet
2.2 Description of channel processor
8- Connecting the earth
9- F-type connector for signal input from the previous processor or from the
antenna
10- F-type connector for signal output to the following processor
11- Infrared transmitter
12- Programming indicator
13- Programming mode switch
14- Indicator that channel input level is correct
15- Power supply control connector
16- Infrared receiver
17- Boxes in which to note input and output frequencies/channels
18- F-type connector for signal output to the monochannel amplifier
19- Upper and lower connection bridge (41.5mm)
20- Technical datasheet
3.

INSTALLATION

The diagrams in the APPENDIX show how to perform a standard assembly
and connections.
Placing loads of 75Ω Ω
3.1
Ensure that the diplexing output of the last processor is charged with a 75Ω
RC-110 (code: 9080019) load.
SERIE 905-PC
Fig. 5 - RC-110 loads
RC-110
W DC
ENG - 19