Télécharger Imprimer la page

IK e Foam Pro 2 Mode D'emploi page 6

Publicité

STORAGE
• Store in a clean, dry place, without corrosive gases, and away from direct sunlight and excess heat or cold. It is
recommended to store between 10°C/50F and 25°C/77F in environments with relative humidity below 65% RH. Never
at temperatures exceeding 60°C/140F.
• During long storage periods, it is recommended to charge the battery every 6 months.
• Store out of reach of children.
SAFETY
• Do not expose the battery to fire or excessive temperatures.
• Do not leave, charge or use the batteries in the car or similar places where the temperature can reach 60°C/140F.
• Do not expose the battery to water or high humidity.
• Never open the battery.
• Do not allow any leakage of battery fluid to come into contact with your skin or eyes. In the event of having occurred,
clean with cold water and contact your doctor/physician immediately.
6
TROUBLESHOOTING TABLE
IDENTIFIED PROBLEM
The compressor fails to start.
The battery does not charge up or
its autonomy has been reduced.
The compressor works, but the
spraying is not suitable.
Motor works but does not reach
the required pressure.
7
TECHNICAL SPECIFICATIONS
Net weight
Gross weight
Useful capacity
Total capacity
Maximum pressure
Battery (Lithium-ion)
Type of load
Recommended charger
Noise level
Code
8
WARRANTY
Our products are guaranteed for a period fixed according to the current legislation in each country, from the date of purchase
by the user, against any manufacturing or material defect. The warranty is strictly limited to free replacement of parts that our
services consider defective. The warranty shall not apply in case of improper use of our materials, disassembly and/or alterations
performed to our devices, and to those parts of normal wear and tear that require maintenance The warranty shall not apply in case
of negligence, imprudence and irrational use of the material. To invoke this warranty, send us the part subject matter of the claim,
carriage free, together with the receipt or the purchasing invoice.
POINTS TO BE VERIFIED
The switch is turned off
The battery is depleted
Check if the pump and electronics are damaged
Mains adaptor is incompatible or damaged
Cable is damaged
The battery is old. Its service life is nearing its end (battery life
<65% of nominal)
Clean nozzle felt and ensure correct chemical and dosage.
Air leakage between the tank seal and the head
- Seals and materials are resistant to most acids and cleaning
1.4 Kgs
1.15 Kgs
- Strong translucent tank with level indicator.
- Innovative and ergonomic design.
1.5l
- Base for greater stability.
- Large opening for easy filling and cleaning.
2l
- Safety lock.
- 3 bar (43.5 psi) safety valve with depressurization option.
3.5 bar
- Protective sleeve for valve chamber.
7.2V / 3200mAh
- Easy assembly and taking apart for cleaning and maintenance, tool
USB-C
- Special "foam" even fan type nozzle.
- Ability to identify content via coloured caps.
5V-2A
- Storage of nozzles inside the coloured caps.
<97db
81682
Turn the switch on to the working position
Recharge the battery
Contact the distributor
Replace mains adaptor
Replace usb cable
Contact the distributor
Watch video https://www.iksprayers.com/es/faqs
Check that the tank seal surface is free of markings
products.
free.
ACTIONS TO BE CARRIED OUT

Publicité

loading

Produits Connexes pour IK e Foam Pro 2

Ce manuel est également adapté pour:

8168281682200