Télécharger Imprimer la page

IK e Foam Pro 2 Mode D'emploi page 5

Publicité

4. To begin spraying, make sure the safety lock is off (Figure 2.3). When the pressure drops the compressor will switch on
automatically. When you stop spraying, press the power button to turn off the compressor; otherwise, the compressor
will continue to run until it reaches maximum pressure again.
5. Once the work is finished, activate the safety lock (Figure 2.4a) and release the pressure by pulling the safety valve
(Figure 2.4b). Lastly, press the power button for 3 seconds to switch the system off again.
6. If more than one appliance is used with different chemicals, use the identification marker to identify the contents of each
appliance by placing it on the end of the handle (Figure 2.5a). To remove it, pull it in the direction shown by the arrows
(Figure 2.5b) using a tool or pointed instrument (Figure 2.5c).
3
MAINTENANCE
1. After each use, depressurise the sprayer (Figure 3.1).
2. Collect and dispose of the residual amount according to the legislation, prescriptions, and applicable regulations.
3. Clean the appliance with water.
4. In the event of obstruction of the nozzle, clean it with water and do not use metallic objects (Figure 3.2).
5. In order to prolong the life of the joints, regularly apply some drops of oil or grease on the moving parts (Figure 3.3).
6. To access the valve chamber (165), remove the cylinder guard by pulling it firmly (Figure 3.4).
7. To access the rod's O-ring (603), unscrew the piston and remove it until leaving visible the aforementioned O-ring (Figure
3.5).
8. The apparatus has a felt pad installed in front of the nozzle (Figure 3.6a). This filter is to be cleaned with water when it
is dirty. If it is completely damaged or is extremely dirty, replace it with a spare part. In the device there is a strip with 10
supplementary filters (Figure 3.6b). Remove the used filter using a pointed object. (Figure 3.6c).
9. Store the sprayer indoors protected from frost and extreme heat (between 5ºC and 30ºC (40ºF & 85ºF)) (Figure 3.7).
4
USES AND SECURITY REGULATIONS
1. Always follow the instructions and dosages on the packaging labels, that the manufacturer recommends for the chemical
product to be used.
2. To avoid any consumption of the product, do not eat, drink or smoke while preparing and spraying.
3. Do not spray on people, animals, electrical installations, flames, open fire, or other sources of ignition.
4. In case of poisoning, consult your doctor, taking the chemical product packaging with you.
5. Never dispose of waste product or cleaning residues near water courses, wells, etc.
6. Use suitable safety equipment, mask, goggles, gloves, footwear etc in order to avoid contact of chemical products with
skin, eyes and mouth.
7. Do not modify the apparatus. Do not connect it to an external pressure source. Do not obstruct or strike the safety valve.
Do not use if damaged, deformed or changed from its original shape.
8. Compressing air generates heat, so compressors tend to get hot. Avoid overheating the device. Do not work in high
temperatures (max 40ºC/104F) or in strong sunlight. If you hear an intermittent noise from the compressor, turn it off and
let it cool down.
9. Do not operate the power tool in potentially explosive atmospheres where flammable gases, liquids or dusts are present.
Electric motors generate sparks that can ignite dust or vapours.
10. Keep sprayer out of reach of children.
11. Use the device only with compatible substances (Scope of Application).
12. Do not use the equipment if you are tired or under the influence of drugs, alcohol or medication.
13. To prevent the device from starting up accidentally, make sure it is switched off before it is stored or transported.
14. Never purge nozzles or valves by blowing with your mouth.
15. Use only spare parts and accessories from the manufacturer.
16. We will not be held liable for any damage caused by the use of foreign parts.
17. Depressurise the tank completely before filling, after use and before carrying out work relating to maintenance.
18. Once the spraying work is finished, lock the handle to avoid any involuntary operation.
19. This appliance can be used by children aged 8 years and above and persons who are physically, sensory or mentally
challenged or lack experience and knowledge if they have been given supervision or instruction concerning the use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Children
shall not make cleaning and user maintenance without supervision.
20. It is a prerequisite for the correct use of the sprayer to comply with the operating instructions provided by Goizper.
Consequently, Goizper shall not assume any liability arising from incorrect or inappropriate use of the equipment.
21. STATE OF CALIFORNIA PROPOSITION - PROP 65  WARNING: This product can expose you to one or more chemicals,
including lead, which is known to the State of California to cause cancer and reproductive harm. Wash hands after
handling. For more information go to www.p65warnings.ca.gov
5
BATTERY
CHARGING
• Do not charge using a cigarette lighter charger.
• The sprayer has a LED indicator. The flashing LED indicates that the battery is charging. When the battery is fully charged,
the LED turns solid green.
• Plug in the charger only indoors, in a dry place and out of reach of children. Charge in environments with temperature
between 5°C/41F and 30°C/85F, 65% RH.
• Do not use the charger in explosive environments.
• Never plug in or unplug the charger with wet hands.
• Stop charging if the charging is not completed within the specified time.

Publicité

loading

Produits Connexes pour IK e Foam Pro 2

Ce manuel est également adapté pour:

8168281682200