Publicité
▶
If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly
visible and where there is no risk of fire, at an adequate distance from flammable materials. Allow
the battery to cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti
Service or read the document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion
batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by
scanning the QR code at the end of these operating instructions.
Description
1
Product overview
Cutting arm (movable)
@
Cutting arm (stationary)
;
Release button (depth gauge)
=
Depth gauge
%
Function selector switch
&
Control switch
(
Grip
)
Release button, battery
+
Battery status indicator
§
Intended use
The product described is a cordless (battery-powered) threaded-rod cutter. It is designed for cutting
threaded rods of sizes:
• W3/8 (mild steel, galvanized, or stainless steel)
• M6 and M8 (mild steel, galvanized, or stainless steel)
• M10 (only mild steel, galvanized)
The product is not suitable for cutting stainless steel M10 threaded rods.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum
performance, Hilti recommends the batteries stated in the table at the end of these operating
instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
Items supplied
Cordless threaded-rod cutter, waste container, depth gauge, parallel guide, set of cutting edges, hex
key, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store
or at: www.hilti.group
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of
health.
Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶
If the release button is pressed with a battery inserted in the product, subsequently check that the
battery is correctly re-engaged and secure.
*2362838*
28
2362838
Scaffold hook
/
Release button (mounting adapter)
:
Mounting adapter for accessories
∙
Parallel guide with M6 adapter
$
Waste container for offcuts
£
Work-area light (LED)
|
Cutting blade
¡
Hex key (4 mm)
Q
Installation slot for accessories
W
21
Publicité
