BATTERy CHARGER
W A R N I N g
If the battery is inserted into the charger when warm or hot, the CHARGING LED indicator light
on the charger may switch on and illuminate ORANGE. If this occurs allow the battery to cool
outside of the charger from approximately 30 minutes.
CHARgER MAINTENANCE
• Keep the charger clean and clear of debris. Do not allow foreign material into the recessed
cavity or on the contacts. Wipe with a dry cloth. Do not use solvents, water, or place in wet
conditions.
• Always unplug the charger when there is no battery pack in it.
• The battery pack may be stored in the charger. however, it is recommended to disconnect
the charger from the power source. To ensure safety and reliability all repairs should be
performed by a qualified service technician.
• Check that the charger contacts have not been shorted by debris or foreign material.
CHARgER MOUNTINg (See Figure 6.)
1. This charger can be installed hanging on a wall using two screws (not supplied)
2. Locate the placement for the charger to be wall mounted.
3. If fastening to wood studs use 2 wood screws.
4. Drill two holes 2 3/8" (6 cm) on center ensuring they are level.
5. If fastening to drywall use wall anchors and screws to secure the charger to the wall.
16
Fig. 6