Publicité
ASSEMBLy INSTRUCTION
BATTERy
IMPORTANT! The battery pack is not charged when it is purchased. Before using the hedger
for the first time, place the battery pack in the battery charger and charge. Make sure to read all
safety precautions, and follow the instructions in the Battery Charger section.
To remove the battery (See Figure 2.) :
1. Slide the latch button on the battery pack down (1) and hold.
2. Grasp the trigger handle (2) firmly. Pull the battery pack out of the handle.
The battery pack fits snugly into the handle to prevent accidental dislodging. It may require
NOTE:
a strong pull to remove.
To install the battery (See Figure 2.):
1. Align the tongue (3) of the battery pack with the cavity in the handle housing.
2. Grasp the trigger handle (2) firmly.
3. Push the battery pack into the handle until the latch locks into place.
IMPORTANT! DO NOT remove the blade assembly unless it needs sharpening, straightening, or
replacing. Take it to a qualified person for repair.
W A R N I N g
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the Off position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the Off position before
inspecting, adjusting, or performing maintenance on any part of the hedger.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
2
11
3
1
Fig. 2
Publicité
