Publicité
Operation
Remote Control and Keyless Entry
PRE-PROGRAMMED REMOTE CONTROL INCLUDED, NO NEED TO PROGRAM THE
REMOTE.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote controls are
NOT compatible.
PROGRAM USING THE MOTION DETECTING OR MULTI-FUNCTION CONTROL PANEL
1.
Press the LEARN button on the door control to enter programming mode. The command LED will flash
once.
2.
Press the LEARN button again, the command LED will flash once again.
3.
Remote control: Press the button on the remote control that you wish to operate your garage door.
PROGRAM USING THE PUSH BUTTON DOOR CONTROL
1.
Press and hold the light button and the push button until the push button LED begins to blink.
Remote control: Press the button on the remote control that you wish to operate your garage door.
2.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
Repeat the steps for programming additional remote controls or keyless entry devices. If programming is
unsuccessful, repeat the steps using the LEARN button on the garage door opener.
Push
Button
OR
PROGRAM USING THE GARAGE DOOR OPENER LEARN BUTTON
1.
Locate the LEARN Button.
2.
Press and immediately release the LEARN button. The LEARN LED will glow steady for 30 seconds.
Within 30 seconds...
3.
Remote Control: Press and hold the button on the remote control that you wish to use.
Release the button when the garage door opener lights blink or two clicks are heard.
1-2
3
LIGHT
Button
HomeLink®
If your vehicle is equipped with HomeLink®, a Compatibility Bridge™ (not included) may be necessary for
certain vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
41
LEARN
Button
LEARN LED
Publicité
