Cleaning The Ashes Drawer; Cleaning The Tube Heat Exchanger; Glass Cleaning - Elledi Star 10.2 C Manuel D'utilisation Et D'entretien

Cleaning the ashes drawer:

The ashes drawer must be cleaned every day, depending however on the amount of time the stove is used and the type of pellet used.
To start-up and clean, open the stove door and remove the brazier.
Also vacuum here if material
falls out while releasing the
drawer.
Here below is a summary of the control and/or maintenance interventions necessary for correct stove operation.

Cleaning the tube heat exchanger:

During operation, dust and soot are deposited on the surface of the heat exchanger tubes. To ensure smooth operation throughout
the season, it is advisable to periodically clean the heat exchanger when the stove is cold. Using the cold handle, extract the scraper
rod and firmly move the scraper back and forth.
Scraper rod in its seat

Glass cleaning

The glass door must be cleaned with the thermo-stove cold, using a cotton rag or kitchen paper towel. Use a specific product for cleaning
pellet stove glass that can be purchased in specialised stores. Glass cleaning must take place after delicately vacuuming all ashes from
the interstices of the door and the gasket.
We recommend not exceeding in the quantity sprayed, carefully avoiding to spray directly into the gaskets.
STAR 10.2 C- STAR 12.2 C
Use and maintenance manual
Scraper rod extracted
Rev.1 03/08/2017
Page 58
Insert drawer here after completing
the cleaning.
EN