Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
Connection to the power grid will be preferably through the rear plug.
In order to assemble the hand dryer complete the following steps:
Make four drill holes 0.31" (8 mm) in diameter in the wall, using the provided template
(Figure 4).
Clean the dust away from the holes and insert the wall plugs.
Pass the electrical cables from the power grid through the 0.87" (22 mm) diameter hole
which is situated above the device‟s terminal strip (Figure 5).
Figure 4
Firmly screw the base of the device to the wall (Figure 6), ensuring that the 4 silent-
blocks are correctly placed between the base and the wall.
Connect the electrical cables to the hand dryer‟s terminal strip. Connect the cables
corresponding to the two phases (N and L) and to earth in the corresponding sockets of
the terminal strip, as indicated by the engraved letters (Figure 7).
Figure 7
Figure 8
Figure 5
The hand dryer must be installed permanently wired to the main
power and the installation, operation and maintenance must be
conducted in accordance with the National Electrical Code,
ANSI/NFPA 70 applicable work and safety codes.
The hand dryer must be installed against a solid surface only (wall,
partition, or similar).
Connect earth wire supplied from the upper rib of metal casing to
grounding terminal on base plate as shown on Fig.8.
Carefully place the casing on the base of the device. To do so
place it over the base with a slight incline from top to bottom, in
such a way that the tab in the casing correctly inserts into the
corresponding slot in the base (Figure 8).
Place the screws for fixing the casing to the base, fixing them
tightly using the special spanner provided (Figure 9 and 10).
Figure 9
-3-
www.bradleycorp.com
Figure 6
Figure 10
Publicité
Table des Matières
