Bradley 2901-287300 Manuel D'installation Et D'utilisation page 2

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

www.bradleycorp.com
INTRODUCTION
2901 series hand dryers offer the following technical features:
Automatic operation. Hand detection is based on IR-type movement sensors.
These hand dryers have a provision for grounding.
They provide a potent beam of air, intense and even.
The distance for detecting hands is adjustable.
The speed of the air generated by the hand dryer can also be adjusted, to achieve an
optimum balance between the drying power and noise level.
The hand dryers include an intelligent detection system which eliminates static „targets‟
(marble, shelves or similar). After detecting a static target, the dryer will disconnect a
few seconds later.
It includes a vandal-proof system with an automatic stop. Maximum continuous
functioning time is 60 seconds.
It includes a universal high speed motor that is activated gradually to control the inertia
of its ignition torque and thus ensure a longer useful life of the hand dryer.
ONLY A QUALIFIED TECHNICIAN CAN INSTALL, ADJUST AND MAINTAIN THIS HAND
INSTALLATION
Removal of the casing
The hand dryer is supplied with the casing fitted to the base without tightening (Figure
1).
Carefully remove the casing since it is connected to the base by a tab that joins the two
pieces (casing and base) at the rear (Figure 2).
Remove the casing keeping it at an angle at all times (Figure 3) until the upper tab is
completely withdrawn, taking care to:
 not damage the internal components, in particular the electronic circuit,
 not scratch or damage the LED sensor screen,
CAUTION : RISK OF ELECTRIC SHOCK – WHEN CASING IS DISMANTLED, ACTIVE
Figure 1
not damage the surface of the casing.
PARTS MAY BE ACCESSIBLE.
DRYER.
Figure 2
- 2-
ENGLISH
Figure 3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2901-2874002901-28732901-2874

Table des Matières