Phonocar VM 172 Instructions De Montage page 8

Warning
This unit is not intended for installation in the front driver/passenger area where it may be seen by the dri-
ver. Installation of this unit where it may impair the driver's concentration is dangerous. The manufactureror
retailer assumes no responsibility for failing to obey the above warnings.To reduce the risk of electric shock,
please do not exposethis unit to rain, moisture or attempt to open the unit. There are no userserviceable
parts inside the unit.
Caution:
1. Please read these instructions carefully before operating the unit and observe the relevant warnings.
2. Please keep away from moisture and direct sunlight.
3. Do not attempt to disassemble or remodel the unit yourself to avoid electric shock.
4. Please clean the display with a dry and soft cloth.Do not clean the display with any alcohol or chemical
cleanser.
5. Please ask a qualified engineer to install the unit.
6. Do not try to recharge the remote control battery.
7 Please keep the remote control battery away from children.
8. The display may sometimes show pixels (light dot or dark dots) during use. This isnormal and does not
indicate any malfunction.
Functionality
1 OSD function.
2 Support Pal/NTSC system.
3 Blue panel function: if no signal, the panel will be auto-shift to blue mode.
4 Up down/ left right revolving.
5 When the unit has no signal, the monitor will auto-shift blue screen and in few minutes, the monitor will
shut down automatically.
8