Arming And Disarming The System; Stay Arm (Arming The Perimeter); Silent Exit Delay - DSC HS2TCHP Guide De L'utilisateur

Arming and Disarming the System

Arming and Disarming the System

Stay Arm (Arming the Perimeter)

Ask your alarm company if this function is available on your system.
Stay arming bypasses the interior protection (i.e., motion sensors) and arms the perimeter of the system (i.e.,
doors and windows). Close all sensors (i.e., stop motion and close doors). The Ready (
be on. Press the Stay Arm button and/or enter your Access Code and do not leave the premises (if your
installer has programmed this button). During exit delay, the Armed (
to visually indicate that the system is arming.
When the exit delay expires, the Ready LED turns off, the Armed LED remains on and the keypad stops
sounding to indicate that the alarm system is armed.
Note: For SIA FAR listed panels, the Stay Arming exit delay will be twice as long as the Away Arming exit
delay.

Silent Exit Delay

If the system is armed using the Stay Arm button or using the "No Entry" Arming method ([*][9][access
code], the audible progress annunciation (keypad buzzer) is silenced and the exit time doubled for that exit
period only (CP-01 versions only).
Note: For non CP-01 versions, Standard exit time is used.
When Stay Arm is selected from the Home screen:
The display indicates "Exit Delay in Progress," and the pre-programmed exit delay begins.
l
The Armed LED Indicator turns on.
l
If Quick Arm is not enabled by the installer, then a numerical keypad is displayed (see following figure).
Enter a valid access code to proceed.
Figure 4 - Keypad
If Disarm is selected during the exit delay, a numeric keypad is displayed.
Enter (tap) your access code.
l
The arming sequence is aborted and the system returns to the Home screen.
l
The Armed LED turns OFF.
l
) and Ready(
- 9 -
) indicator should
)indicators turn on