Publicité
INSTALLING THE BURN GRATE:
Part Required:
Installation:
The larger lip of the grate, now notched,
installs under the pellet fuel deflector.
The bend along the larger lip should also be
sitting tight to the back of the burn pot (B)
The front lip of the grate should be sitting
flush along the top of the burn pot. ( C )
IMPORTANT:
INSTALLING THE "ARCHED FLAME BROILER":
Parts Required:
1 x #6 Flame Broiler Slide Top
1 x #7 Flame Broiler Main
Installation:
To ensure proper height and angle, the bottom plate of the mounting
bracket (A) should not be within the pellet drop chute area.
If you do need to adjust the bracket, loosen off the three (3)
Phillips screws, lift the bracket and re-tighten the screws.
Take the Arched Flame Broiler,#7, (C) and hold it so that the end with
the cut out and slots is in your left hand. The plate then clips
easily over the adjustable mounting bracket. (B)
Take the Arched Flame Broiler Slider Top, #6, (D) and place it
on top of the main piece, #7, ( C).
This plate is used to slide over the flame broiler opening
OPEN for "Direct" flame searing / char broiling,
Remember this will effect the convection flow.
CLOSED for "Indirect Convection Cooking".
Assembly Instructions
THE PLACEMENT AND MAINTANENCE OF THE BURN GRATE IS VITAL
TO A HAPPY AND FULL RANGE COOKING EXPERIENCE!
13
13
Publicité
