Ardo Calypso Mode D'emploi page 15

en
5. Troubleshooting / fault analysis / Error indicator/ Guarantee
time-display
In the event of an error, the LED display blinks between green and orange. There are three different error-displays:
Voltage too high
• Incorrect or defective
mains adaptor. Input
voltage exceeds 16v...
Further possible errors when using the unit
• Weak or absent vacuum:
Disconnect the PumpSet from the unit. Partly close the connector opening (f) with a finger to test the suction.
However, be careful not to completely cover the opening. If suction is detectable, then the pump is working. Test
the PumpSet in accordance with the separate instructions, (only use the original ARDO PumpSet).
• The pump is not working / no data on the display:
Check the mains supply; if the unit still does not work it is defective.
• In the event that one of these errors occurs, and is confirmed, the unit must be brought or sent back to the point of
sale. The unit must be checked out by trained service personnel, or by the manufacturer of the pump unit.
6. Product Description
The Calypso Pump System consists of the breast milk pump and a pump set (single or double pump set).
The Calypso breast milk pump is a quiet, user-friendly reciprocating pump for personal use. The unit is equip-
ped with a robust plastic housing (Quality: VO) and a simplified, logically organised keyboard with a display
readout. The energy-saving electrical equipment is designed for both mains- and battery-operation.
The sophisticated controls allow each mother to enjoy a comfortable and efficient pumping experience (plus a
tested suckling curve) thanks to the flexible system for adjusting suckle-strength, and cycles.
Suckling Curve
The suckling curve is characteristically stable over the entire
vacuum and cycle area and corresponds closely to your baby's
suckling behaviour. Therefore the breast tissue is not additionally
stressed by pumping.
Voltage too low
• Weak batteries
• Incorrect or defective
mains adaptor...
15
Time-out (general errors)
• Re-boot. Switch off the unit and re-start.
If the error message appears again, the
unit is defective and must be replaced.
• When the display is illuminated green on
an error message: Guarantee Exchange.
(Please refer to section 9 - Guarantee).
• An orange error-display indicates that
the unit must be replaced (and the old
unit properly disposed of by the owner).
en
Ardo medical AG