Publicité
•
replace the damaged parts.
•
tighten the bolts.
•
speak to a person of an approved service center.
•
Store the machine in a dry, isolated and frost-free
area.
7
TROUBLESHOOTING
PROBLEM
POSSIBLE
CAUSE
The motor does
The power
not start.
switch is off.
You do not plug
the power cord.
Electrical outlet
does not supply
sufficient power.
The circuit
breaker is trip-
ped.
The power
switch is on, but
you do not pull
the gun trigger.
The machine
The diameter of
does not get
garden hose is
high pressure.
too small.
The garden hose
is blocked.
The water supply
is not sufficient.
You do not install
the nozzle onto
the spray wand.
The water intake
filter is blocked.
English
PROBLEM
SOLUTION
Set the power
switch to the
"ON" ( | ) posi-
tion.
Connect the
power cord to
The output pres-
the power sup-
sure varies high
ply.
and low.
Try another elec-
trical outlet.
Let it cool, and
start the ma-
chine again.
Pull the gun trig-
ger.
Replace with a
1" (25 mm) or
5/8" (16 mm)
garden hose.
Make sure that
the garden hose
is free from
blockage.
Open the water
suppy fully.
Install the nozzle
onto the spray
wand.
Remove the filter
and make it
clean in warm
water.
7
POSSIBLE
SOLUTION
CAUSE
The water supply
Open water sup-
is not sufficient.
py fully. Make
sure the garden
hose is free from
blockage.
The pump ab-
1. Make sure
sorbs air.
that the ho-
ses and fit-
tings have no
problem.
2. Turn the ma-
chine off.
3. Pull the gun
trigger until a
stable flow of
water comes
out through
the nozzle.
The water intake
Remove the filter
filter is clogged.
and clean it in
warm water.
The supply volt-
Make sure that
age is low.
only the pres-
sure washer op-
erates on the cir-
cuit.
The gun, hose or
Operate distilled
nozzle are calci-
vinegar through
fied.
detergent tank.
EN
Publicité
