Publicité
Modello - Model - Modèle
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
25. MOTORS REPLACEMENT
Follow these instructions:
•
Remove the tray from the vending machine and place it on your
work top.
•
Remove the tray spiral and motor.
•
Remove the spiral.
•
Remove the electric connectors.
•
Replace the motor and reverse the order of the above operations
for assembly.
26. REPLACEMENT OF DRAWER SEPARATORS
(TROCADERO PRO, TROCADERO BOOST)
The procedure is as follows:
• Tilt (right) and lift the retainer.
• Replace the separator.
• Fix the separator by reinserting
the retainer.
27. TRAY ARRANGEMENT MODIFICATION
The arrangement of the trays inside the vending machine can be modified by moving the guides which support the trays.To carry out
this operation, it is necessary to:
•
Pull out the drawer.
•
Lift and pull out the left and right drawer guides and disconnect the block.
•
Set the desired height of the drawer and insert the guides removed previously.
•
Connect the block and reinsert the drawer.
WARNING! It is not necessary to use any screws to insert the drawer guides.
BRERA PRO / BRERA SLAVE PRO / BRERA BOOST
CHELSEA PRO / CHELSEA BOOST
TROCADERO PRO / TROCADERO BOOST
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
3 6 / 1 0 8
PAGE
UM000758
N° DOC
Publicité
