Dyson Pure Hot+Cool Link Guide D'utilisation page 7

Night mode
The night mode will dim the display and run quietly, making it ideal for use while sleeping.
When night mode is enabled (indicated by an illuminated
crescent moon symbol in the bottom right corner of the display),
the display will dim and after 5 seconds will fade to off.
The crescent moon symbol remains illuminated.
If the appliance is not in auto mode, the airflow speed will reduce to level 4. When night mode is activated, if it is already
below level 4, it will remain the same. This can be manually changed if desired. The display will illuminate briefly, then fade
as before. If in auto mode the airflow speed will be reduced automatically.
Oscillation
Oscillation control
To start the appliance
oscillating, press the
oscillation control button.
To stop the appliance
oscillating, press it again.
The appliance will not
oscillate when the control
buttons are pressed.
Diffused and focused modes
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to a whole
room airflow.
Heating and cooling modes
work in this mode.
12
5 secs
Airflow speed control
Airflow speed control
To change the airflow
speed press the airflow
control button. The digital
display will show the new
speed; after 3 seconds it will
change back to the target
temperature.
Focused mode
Press the narrow angle button
to change from a whole room
airflow to a personal directed
airflow.
Heating and cooling modes
work in this mode.
Sleep timer
The sleep timer will
turn your appliance
off once the time
set has passed.
To set the sleep timer, select the desired time. When time
reaches zero, the appliance will go into standby mode.
To cancel, increase the time until two dashes appear.
Clearing blockages
Ensure the appliance is unplugged. If the appliance has been in use, leave for 1 to 2 hours in order to allow the appliance to cool
down completely. Look for blockages in the air inlet holes and in the small aperture inside the air loop amplifier. Use a soft brush
to remove debris.
Cleaning
Unplug from the mains electricity supply. If the appliance has been in use, leave for
1 to 2 hours before cleaning to allow the appliance to cool completely. Dust may
accumulate on the surface of the machine. Wipe dust from the loop, filter unit and
other parts with a dry or damp cloth when dust accumulates. Do not use detergents
or polishes.
Tilt function
Carefully hold the base and the main body.
Tilt forward or backward for the required airflow angle.
CAUTION: hot when in use
This appliance is hot when in use and for
a short period after use. Do not let bare
skin touch hot surfaces. If children are
present, consider positioning the appliance
out of their reach.
13