Hach POLYMETRON 8811 Manuel D'utilisation De Base page 17

Sequencer display Description
Mes. overrange Measurement superior to the limit
Mes. underrange Measurement inferior to the limit
Ratio error Ratio 8921 error
Faraday cell err. Faraday cell error
Pot. overdrive Output overdrive
No sample Lack of sample
ADC error Photometer error
T°C overrange Temperature (in°C) exceed the programmed upper limit
T°C underrange Temperature (in°C) is below the programmed lower limit
Compensat. error Compensation impossible
Convert. error Conversion concentration<->conductivity impossible
Convert over Conversion error
Calibrat. error. Conc. after 1st addition is under 3 times the original concentration of
the sample [C inj.1] < 3 x [ Co ]
Calibrat. error. Conc. after 2nd addition is under expected value [C inj. 2] < 3 x Co +
[C inj.1]
Calibrat. error. Conc. after 2nd addition is under 5 times the original concentration of
the sample [C inj. 2] < 5 x Co
Calibrat. error. Non convergent research
Calibrat. error. Offset error
Calibrat. error. Slope error
Calibrat. error. Flow-rate error during calibration
Error 29 Flow-rate error in measuring mode
Level sample Level in the 8810 reactor vessel
Over tit time Titration time exceed programmed "Limit time" value in "TIMING"
menu
Calibrat. error Calibration error
Level reagent Reagent level
Level Cal. Sol. Calibration solution
Level Cond. Sol. Conditioning solution
Level Clean. Sol. Chemical cleaning
Slope calibrat. Slope error
Point not found Final point not found
Return process After a "grab sample" analysis, the waiting time is exceeded (10mn).
Please return to "Process sample" analysis
Table 2 Error messages
Analyzer message
ER : 01
ER : 02
ER : 03
ER : 04
ER : 05
(ER02 w/ a 8980)
ER : 06*
ER : 07
ER : 11
ER : 12
ER : 13
ER : 16
(ER21 w/ CIP)
ER : 17
(ER22 w/ CIP)
ER : 21
ER : 22
ER : 23
ER : 24
ER : 25
ER : 26
ER : 27
ER : 29*
ER : 30*
ER : 31
ER : 32
ER : 33
ER : 34
ER : 35
ER : 36
ER : 37
ER : 38
ER : 39
English 17