Thermador T24UW820LS Guide D'installation page 11

2. Position the door at less than 90° so the mechanism of the hinge does not obstruct the hole and
insert the Door Stopper Pin into the hole.
3. Align the Pin with the bottom hole of the hinge and push the Pin firmly until it gets locked.
4. Now place back the Hinge Cover to protect the Hinge mechanism. First, be sure that the metallic
rib of the hinge is into the open slot of the Hinge Cover. Then, push and slide the Cover firmly in
the direction of the Hinge until it locks into its original place.
OPEN SLOT
5. Be sure that the Hinge Cover is locked in its place. It is important to place the Hinge Cover back
because it helps to protect the mechanism of the Hinge and also your fingers from the
mechanism.
The Cover
locks here
LESS THAN
90°
BOTTOM
HOLE
METALLIC RIB
And locks
under this tab.
PUSH
FIRMLY
110°
90°
2mm
1/16"
675mm
26 1/2"
Now, the door opens only 90°
603mm
23 3/4"
66mm
2 1/2"
Page | 11