Publicité
3 Centering the running belt
During the exercise, one foot is pushing the running belt stronger than the other. According to that, the belt will be
moved out of the centre. Normally the belt will be centered automatically, but during longer exercise, it can be, that
the belt is off the centre. In this case, please follow up the following instruction. At the rear end of the running deck,
there are 2pcs of Allen screws, which will be used for centering the belt. Don't use any loose clothes during
centering.
- Please turn the Allen screw not more than ¼ turn for each step.
- Stretch one side and release the other side.
- the speed of the belt has to be 6km/h, but make sure, that nobody is running on the belt.
If you finish the centering, walk on the treadmill for about 5 minutes, with the speed of 6km/h. If the running belt is
still not in centre, please centre the belt again. Pay attention, that you don't force the belt too much, a shorter life will
be caused. If the gap on the left side is too big, please
- turn the left screw a ¼ turn clockwise (tighten it)
- turn the right screw a ¼ turn anticlockwise (loose it)
If the gap on the right side is too big, please
- turn the left screw a ¼ turn anticlockwise (loose it)
- turn the right screw a ¼ turn clockwise (tighten it)
4 Tighten the belt
after longer exercise, the tension of the belt will decrease. It can be checked if you put one foot on the belt and belt
will stop. To solve this problem, please turn both screws clockwise for ¼
turns. Please do not turn them more. If the belt is running out of the centre, please adjust it like described under
above center the belt.
Publicité
