Publicité
1.1 Plug in the power cord and press the power key at the down front part of the machine. If the machine is not
operated or moved for a long time, please turn off the power.
1.2 Nip the safe key on the clothes and put the switch of magnet into the computer. If the safety magnet is not put
into the assigned location, then the machine will not work.
2. START
2.1 Press START/STOP, the machine begins to work with starting speed 1.0KM/h
2.2 Press SPEED can control the speed, with one press 0.1 KM/h will be increased or decreased. Press the key
without stop can get to the speed you want.
3. TWO WAYS TO STOP THE MACHINE
3.1 Pulling the safe key will put a quick stop to the machine which will beep. Before restart, please put the yellow
magnet to the original place.
3.2 Press START/STOP, the machine will stop working
IMPORTANT SAFETY INSTRUCTION
1.
The machine is for home use
2.
The voltage for the machine is 220V.
3.
Before operating the machine, please do 10-minute warm-up and wear clothes and shoes that are suitable for
sports
4.
Do not stand on the motorized treadmill when you adjust, test or start the motorized treadmill.
5.
Be careful when you get on or off the machine. Before starting the machine, please grab the handlebars and
place your feet on the side rails (not the running belt). After starting the machine, stand on the belt with the
machine operating at the lowest speed. Then increase the speed gradually. Before getting off the machine,
please decrease the speed to the lowest level in case of any danger.
6.
When operating, press the safety at any time, the motor will stop working and the controller will give warnings.
7.
Children should be supervised by adults when they play on or beside the machine.
8.
The motorized treadmill should be protected from sunshine, damp and dirt. All the parts shall be cleaned often.
When the machine is free from using for a long time, please don't place any objects or stand on the machine.
CARE AND MAINTENANCE
1 Care
For cleaning the running belt use a vacuum cleaner. If the belt is really dirty, please use a wet cloth. Do not use any
cleanser. When cleaning, use only a moist cloth and avoid harsh cleaning agents. Ensure that no moisture comes
into the computer. Components that come into contact with perspiration,
need cleaning only with a damp cloth
.
2 Lubrication
The treadmills have already been spread with "Silicone Oil" in advance before leaving the manufacturing plant.
Silicone oil is without volatility and has gradually permeated through the running belt. There will be no need to re-
spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". "Silicone
Oil" may be re-spread once the resistance has been increased and the running belt starts
rubbing against the running deck. To hold open the running belt from two sides, apply the
silicone oil with an even motion on the center of the running deck. Allow the silicone oil to
'set' for one minute before using the treadmill.
Attention: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add
any other oil ingredient; otherwise the treadmill will be damaged. Do not over-lubricate
the walking board. Excess lubricant should be wiped off with a clean towel.
Publicité
