Publicité
WARNING! Electrocution hazard
The appliance shall be installed in accordance with national wiring regulations.
If the appliance replaces a window or hatch with a safety relevant forced venting function, an additional
safety venting device (e.g. a mushroom fan or similar) needs to be added. In doubt consult the vehicle
manufacturer.
CAUTION! Risk of injury
Improper installation of the ventilation system can result in irreparable damage to the appliance and put
the safety of the user at risk.
Always have someone to help you carrying or liing the ventilation system.
Before installation, check the location of existing wiring harnesses, wires and other components within
the installation area, in particular those which are not visible, when installing the appliance (when
drilling or screwing etc.).
Attach and lay the cables so that they cannot be tripped over or damaged.
Always wear the protective goggles and gloves.
NOTICE! Damage hazard
Use cable ducts to lay cables through walls with sharp edges.
Do not lay loose or bent cables next to electrically conductive materials (metal).
Do not pull on the cables.
Observe the structural strength of the roof of the vehicle. The roof of the vehicle must be able to bear
the weight of the ventilation system without being indented or deformed. In doubt consult the vehicle
manufacturer.
Choosing the way of installing the ventilation system
NOTE
• Choose a flat and sufficiantly level area at the center of the vehicle.
• The roof inclination of the installation surface may not ecxeed 5°. A downwards inclination in the driving
direction of up to 15° is possible.
Choose your way of installing the ventilation system:
• Make a new opening (A). In this case the opening must be reinforced by an appropriate frame.
• Use an existing opening in the vehicle (B) such as a roof hatch or replacing an old device.
A
B
EN
7
Publicité
