Publicité
Maintenance and cleaning
To ensure a long, trouble-free useful life for your unit,
proceed as follows:
To clean the motor and base used a cloth. Never use
alcohol, solvents or other inflammable liquids.
Never immerse the unit in any liquid.
If you notice unusual noises or vibrations, send the
unit to your technical assistance service.
This unit is designed to work correctly on the four
rubber legs (D).
Precautions
Before connecting the unit to the mains, check that
the power supply is 230 V, 50/60 Hz.
Discard any cracked or damaged brush or grinding
wheel: if these elements break during operation they
could cause serious accidents.
Before starting work, ensure that the brush-
holder/wheel holder is firmly attached to the motor
shaft.
When handling workpieces, use safety goggles,
gauntlets, a face mask and a suitable safety screen.
We recommend MESTRA Ref. 080200 or 080210
screens.
Do not allow children or unskilled personnel to hand-
le the unit.
If the motor shaft locks during normal operation, dis-
connect the unit from the mains before attempting to
release it by turning it manually.
Never polish, brush or grind materials which may gi-
ve off particles which are toxic if inhaled.
Before starting to polish or grind a workpiece, check
the motor spin direction: the attack angle depends on
this direction.
Never use the unit close to solvents, alcohol or other
inflammable materials. Take all possible precautions
when grinding materials which may give off sparks.
Never use the unit without proper exhausters.
Keep the working area clean and tidy in order to pre-
vent accidents.
Wear proper working cloth. Loose cloth, hanging or
long hair could be caught by the machine.
Make sure that you switch the power Off before
plugging the unit, in order to avoy sudden start of the
motor.
Disconnect the unit from power supply before chan-
ging the wheel.
Technical data
Power supply: ....................................... 230 V, 50/60 Hz
Power: ................................................................... 200 W
Speed: ..................................................... 2000-5000 rpm
Height: ................................................................185 mm
Height of shaft centre line:..................................140 mm
Width with brush holders:...................................270 mm
Weight: .................................................................. 2.6 kg
7
Publicité
