Publicité
Jandy
Single Element Cartridge Pool & Spa CS Filters | Installation & Operation Manual
®
Section 5. Filter Disassembly and
Assembly
WARNING
Never attempt to assemble, disassemble or
adjust the filter when there is pressurized
air in the system. Starting the pump while
there is any pressurized air in the system
can cause product failure or also cause the
filter lid to be blown off, which can cause
death, serious personal injury or property
damage.
5.1
Filter Element Removal
1. Turn off the filter pump and switch off the circuit
breaker to the pump motor.
2. Open air release valve on top of the filter tank
to release all pressure from inside the tank and
system, see Fig. 6. Close any filter isolation valves
on the system to prevent flooding.
3. Open the filter tank drain. When the filter tank has
drained, close the drain.
4. Remove the locking ring by pushing on the locking
tab and turning the locking ring counterclockwise.
5. Remove the top of the filter. Inspect the tank
O-Ring for damage. Clean or replace the O-Ring as
necessary.
6. Remove the filter element from the tank bottom and
clean or replace as necessary.
7. Place the new or cleaned filter element into the tank
bottom.
8. Use a silicone based lubricant on the new or
cleaned O-Ring and place the O-Ring onto the tank
top.
9. Place the tank top onto the tank bottom. Be sure
the tank halves are seated properly.
Place the locking ring over the filter tank top and
tighten the locking ring by turning it clockwise until
it engages with the stop tab on the lower half of the
tank, see Section 3.4, "Locking Ring and Tank Top
Assembly Installation".
Follow steps 5 thru 8 under Section 4.1, "New Pool
and Seasonal Start-Up".
WARNING
If the breather tube is not fully seated or
is damaged or clogged, trapped air can
cause product failure or also cause the
filter lid to be blown off which can result in
death, serious personal injury or property
damage.
Filter Tank,
Upper
Breather
Tube
Filter Tank,
Lower
Figure 6. Filter Element Removal
Section 6. Maintenance
6.1
General Maintenance
1. Wash outside of filter with water or TSP (tri-sodium
phosphate) with water. Rinse off with a hose. Do
not use solvents or detergents to clean the filter,
solvents will damage the plastic components of
the filter.
2. Check pressure during operation at least once a
week.
3. Remove any debris from the skimmer basket and
hair/lint pot on pump.
4. Check pump and filter for any leaks. If any leaks
develop, turn off the pump and call a qualified pool
service technician.
5. Product safety signs or labels should be
periodically inspected and cleaned by the product
user as necessary to maintain good legibility for
safe viewing.
6. Product safety signs or labels should be replaced
by the product user when a person with normal
vision, including corrected vision, is no longer able
to read the safety signs or label message panel text
at a safe viewing distance from the hazard. In cases
where the product has an extensive expected life or
is exposed to extreme conditions, the product user
should contact either the product manufacturer or
other appropriate source to determine means for
obtaining replacement signs or labels.
7. Installation of new replacement safety signs or
labels should be in accordance with the sign or
label manufacturer's recommended procedure.
ENGLISH
Air Release
Valve
Locking
Ring
Stop
Tab
Filter
Element
Page 7
Publicité
