Installation Instructions; Window Slider Kit Installation - Danby DPA085B1 Guide D'utilisation Et D'entretien

Installation Instructions

LOCATION
WINDOW SLIDER KIT
INSTALLATION
The air conditioner should be placed on a firm foundation to minimize
noise and vibration. For safe and secure positioning, place the unit on a
smooth, level floor strong enough to support the unit.
The unit has casters to aid placement, but it should only be rolled on
smooth, flat surfaces. Use caution when rolling on carpeted surfaces.
Use caution and protect floors when rolling over wood floors. Do not
attempt to roll the unit over objects.
The unit must be placed within reach of a properly rated grounded
socket.
Never place any obstacles around the air inlet or outlet of the unit.
Allow at least 30cm of space away from the wall for efficient air
conditioning.
Your window slider kit has been designed to fit most standard vertical and
horizontal window applications, However, it may be necessary for you to
modify some aspects of the installation procedures for certain types of
windows. Please refer to Fig. 6& Fig.7 for minimum and maximum win-
dow openings. The window slider kit can be fastened with a screw (see
Fig.8).
NOTE: If the window opening is less than the mentioned minimum length
of the window slider kit, cut the end without the whole in it short enough
to fit in the window opening. Never cut out the hole in window slider
kit. (visit www.danby.com for general instruction videos.)
Fig.5
Fig.7
Horizontal
Window
Window Slider Kit
Minimum:72.0cm(2.36ft).
Maxmum:207.0cm(6.79ft).
10
Fig.6
Vertical
Window
Window Slider Kit
Minimum:72.0cm(2.36ft).
Maxmum:207.0m(6.79ft).
Fig.8
Screw
Window
slider
kit