United States Stove Company US3200E Manuel D'instructions page 17

WIRING DIAGRAM
DANGER: SHOCK HAZARD. DISCONNECT POWER SOURCE BEFORE INSTALLATION AND WHENEVER
CAUTION: MOVING PARTS CAN CAUSE INJURY. DO NOT OPERATE WITH COVER REMOVED.
Blower
Rheostat
NOTICE: DO NOT ALLOW POWER CORD TO TOUCH HOT SURFACES! KEEP POWER CORD AWAY FROM
NOTICE: ANY REPLACEMENT WIRING MUST HAVE EQUIVALENT INSULATION AND TEMPERATURE RATING
INSTRUCTIONS SPECIFIC FOR CANADIAN
INSTALLATIONS
Do not obstruct the space under the heater and do not
obstruct the combustion air openings.
Refer to the chimney manufacturer's instructions for
disassembling the chimney for transportation of a
transportable building.
The parts or materials to be employed for ember
protectors and the minimum areas to be covered and
their relation to the space heater, as well as the notice:
"In Canada, to comply with CSA B365, Installation Code
for Solid-Fuel-Burning Appliances and Equipment, any
combustible covering beneath the appliance and/or
within the area extending horizontally at least 450 mm
(18 in) beyond the appliance on any side equipped with a
door, and at least 200 mm (8 in) beyond the appliance on
other sides, shall be protected by a continuous, durable,
non-combustible pad that will provide ember protection.
The 450 mm (18 in) ember protection required on any
SERVICING BLOWER ASSEMBLY.
Black
White
Black
Black
Attach Ground
Green
To Back Of
Blower Housing
STOVE OR PIPE SURFACES.
Black
Black
White
Power Supply
(105°C).
side with a door shall extend for the full width of the
appliance plus the 200 mm (8 in) required on each side
of the appliance without a door. Where an appliance is
installed less than 200 mm (8 in) from a wall, the ember
pad need only extend to the base of the wall. An ember
pad shall not be placed on top of a carpet unless the pad
is structurally supported to prevent displacement and
distortion.
Note: Do not install the chimney directly at the outlet
of the appliance. A chimney connector (flue pipe) is
required.
If this appliance is installed in a transportable building,
removal of the chimney is required for transportation of
the building.
DO NOT INSTALL IN AN ALCOVE
DO NOT INSTALL IN ANY FIREPLACE
17
Blower
Motor
Blower Specs:
110, 60 Hz AC,
0.55 amp
© 2023 United States Stove Company