Electrolux IK2685TL Notice D'utilisation page 50

• This appliance contains hydrocarbons in
the cooling unit. Only a qualified person
must do the maintenance and the
recharging of the unit.
• Regularly examine the drain of the
appliance and if necessary, clean it. If the
drain is blocked, defrosted water collects
in the bottom of the appliance.
2.6 Service
• To repair the appliance contact the
Authorised Service Centre. Use only
original spare parts.
• Please note that self-repair or non-
professional repair can have safety
consequences and might void the
guarantee.
• The following spare parts are available for
at least 7 years after the model has been
discontinued: thermostats, temperature
sensors, printed circuit boards, light
sources, door handles, door hinges, trays
and baskets. Door gaskets are available
for at least 10 years after the model has
been discontinued. The duration may be
longer in your country. For further
information, please visit our website.
3. CONTROL PANEL
1
Temperature indicator LED
1
Alarm light
2
FastFreeze indicator
3
FastFreeze button
4
Temperature regulator
5
ON/OFF button
3.1 Switching on/off
Switching on
1. Insert the plug into the wall socket.
50 ENGLISH
2 3
5 4
• Please note that some of these spare
parts are only available to professional
repairers, and that not all spare parts are
relevant for all models.
2.7 Disposal
WARNING!
Risk of injury or suffocation.
• Disconnect the appliance from the mains
supply.
• Cut off the mains cable and discard it.
• Remove the door to prevent children and
pets to be closed inside of the appliance.
• The refrigerant circuit and the insulation
materials of this appliance are ozone-
friendly.
• The insulation foam contains flammable
gas. Contact your municipal authority for
information on how to discard the
appliance correctly.
• Do not cause damage to the part of the
cooling unit that is near the heat
exchanger.
2. Press the temperature regulator button if
all LED indicators are off.
Switching off
Keep pressing the temperature regulator
button for 3 sec. All indicators light off.
3.2 Temperature regulation
Press the temperature regulator. Current LED
temperature indicator blinks. When you press
the temperature regulator, the setting moves
by one position. Repeat the procedure until
the appliance reaches the required
temperature.
The temperature range may vary between
2°C to 8°C (recommended 4°C).
The set temperature will be reached
within 24 h. After a power failure the set
temperature remains stored.