Publicité
COMPUTER INSTRUCTIONS
COMPUTER
The supplied computer allows the most convenient training.
Every value relevant to training is displayed in a corresponding
window.
From the beginning of the training session, the required time,
the current speed, the approximate calorie consumption, the
travelled distance ad the current pulse rate are displayed. All
values are counted from zero upwards. If you wish to see one
value displayed constantly during training, select this with the
[M] key. If you wish to see these values in constant alternation,
select the „SCAN" function. The display then changes from
one function to the next at intervals of approx. 6 seconds. The
computer is switched on by briey pressing the [M] key or simply
by beginning training. The computer begins to register and
display all values.
To stop the computer, just stop training. The computer stops
all measurements and retains the last attained values. The
last attained values in the functions TIME, CALORIES and KM
are stored for 4 minutes and training can continue with these
values when training is resumed. The computer switches of
automatically approx. 4 minutes after training is stopped.
DISPLAYS
[SCAN]:
If this function is selected, the current values of all functions are
displayed successively in a constant sequence approx. every 5
seconds.
[SPD]:
The current speed is displayed in kilometres per hour.
(Limit of the display: 999.9 km/h.)
[DIST]:
The current status of the travelled distance is displayed.
(Limit of the display: 999,9 km.)
[TIME]:
The currently required time is displayed in minutes and seconds.
(Limit of the display: 99 minutes.)
[CAL]
The current status of the consumed calories is displayed.
(Limit of the display: 999,0 calories.)
[ODO]:
The current status of the travelled kilometres of all previous
training sessions including current training session is displayed.
(Limit of the display: 9999 km.)
[PULSE]:
The current pulse rate is displayed in beats per minute.
(Displays: 40 – 240 pulse beats per minute.)
KEYS
[M-Mode]:
Pressing this key once briey makes it possible to change rom
one function to another, i.e. the respective functions can be
selected. If the key is held longer (approx. 3 seconds), all last
attained values are deleted.
PULSE RATE
1. Hand pulse measurement
On the left and right side of handlebar two metal contact plates
are insert as pulse sensors. Please take care that both hands
at the same time in normal force on the sensors. During the
heartbeat measurement a heart symbol ashes next to the
pulse display. (The hand pulse measurement serves only for
orientation, as it is caused by movement, friction, sweat etc. it
can come to deviations from the actual pulse. A few people may
cause malfunctions of hand pulse measurement. Should you
have trouble with the hand pulse measurement, we recommend
the use of a cardio chest belt with external pulse display.)
Attention! Heart rate monitor systems may be inaccurate.
Excessive exercising can lead to serious damage or maybe
to death. If dizziness or weakness is felt, stop exercising
immediately.
REPLACING THE BATTERIES
1.
Open the battery compartment cover and then remove
the used batteries.(If the batteries should leak remove
them under increased considering that the battery acid
is not into contact with skin come and clean the battery
compartment thoroughly.)
2.
Insert the new batteries (type (AAA) 1.5 V in the correct
order and taking into account the polarity in the battery
compartment and close the battery cover so that it clicks
into place.
3.
If the computer does not pick up immediately, the function
should batteries are removed for 10 seconds and
re-inserted.
4.
The empty batteries properly in accordance with the
disposal regulations disposed of and do not give residual
waste.
Battery compartment
AAA Batteries
18
GB
Publicité
