Publicité
Safety Notes
• This model may only be used with the operating system designed for it.
• Use only switched mode power supply units and transformers that are designed
for your local power system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.
• This product contains magnets. Swallowing more than one magnet may cause death
in certain circumstances. If necessary, see a doctor immediately.
Important Notes
• The operating instructions are a component part of the product and must therefore
be kept in a safe place as well as included with the product, if the latter is given to
someone else.
• The warranty card included with this product specifies the warranty conditions.
• Please see your authorized LGB dealer for repairs or spare parts.
• Disposing: www.maerklin.com/en/imprint.html
Functions
• This model is designed for operation on LGB two-rail DC systems with conventio-
nal LGB DC train controllers or power packs (DC, 0 – 24 volts).
• The built-in decoder is a multi-protocol decoder (DC, mfx and DCC). The mode of
operation is automatically recognized, with priority for mfx.
• The model is programmed with locomotive address 03 for use with the LGB Multi
Train System (DCC). The locomotive is automatically recognized in operation with mfx.
• Mfx technology for the Mobile Station/Central Station.
Name set at the factory: RhB 353
• The functions can be activated only in parallel. Serial activation of the functions is
not possible (Please note here the instructions for your controller).
• The locomotive cannot be switched to operation from catenary.
Mode of Operation Switch
This model has a mode of operation switch on its floor. The mode of operation switch
offers the following functions:
Pos. 0
Locomotive stopped without current
Pos. 1
Power to lights, sound and motor
Sound
The whistle can also be activated with the LGB sound activation magnets (17050)
included with this model. The activation magnet can be clipped in between the ties on
most sections of LGB track. The magnet is located to the side under the stamped LGB
logo. Place the magnet with the logo on the right or left side of the track in order to
sound the whistle long or short when the locomotive goes over this spot.
Service
Lubrication
The axle bearings and the side rod bearings should be lubricated occasionally with a
small amount of Märklin-Oil (7149).
General Note to Avoid Electromagnetic Interference:
A permanent, flawless wheel-rail contact is required in order to guarantee operation
for which a model is designed. Do not make any changes to current-conducting parts.
8
Publicité
