Publicité
Step 17:
Adjust the tilt angle to 30 degrees. (According to your country's law.) (As shown below.)
Attention.
A flatter angle (for example 25 degrees) is allowed and adjustable, but can only be safely adjusted with license
plates shorter than 200 mm. Otherwise there is a risk that the rear tire will touch the reflector during deep compression,
which could cause damage. Make sure that there is enough space between the rear tire and the reflector when the
suspension is fully compressed.
An angle greater than 30 degrees is not permitted.
Attention.
Secure the license plate holder plate with the M5 lens head screw and the corresponding M5 lock nut. Tighten
both screws on the left and right. Hold the screw with an Allen key and tighten both nuts to 5 Nm. Then tighten both M6
screws on the left and right. Hold the M6 flange head screw with an Allen key and tighten the nuts to 10 Nm.
Before each journey: Before each journey: It is the driver's responsibility to regularly check and maintain the safety-relevant vehicle parts.
Before each journey, check that the product is correctly adjusted and functioning and that all screw connections are tight.
Warranty: Take the time to do a 100% professional job when assembling the product. Take all of our assembly instructions and safety
instructions into account. Incorrect or improper assembly or handling of the product will void the warranty.
Care: Do not use aggressive cleaning agents to care for the items. The items can be cleaned perfectly with a simple, lukewarm detergent
solution.
Environmental information: This article must not be disposed of with household waste at the end of its life. Disposal can be made via
BRUUDT, Bertus Verwoerd, Königsfelderstrasse 24, 49824 Ringe, Tel.: +49 (0) 5944 599 406; E-mail: info@bruudt.de or locally available return
and collection systems.
25
Publicité
