Publicité
Step 15:
Now mount the license plate and adjust the width of the indicators.
The license plate (2 in the figure below) must be mounted so that it rests on the top of the base plate (1 in the
Attention!
figure below).
Use at least 3 mounting points. Be sure to use the top 2 slots provided (C in the image below) for M6 screws (not included).
The third mounting point is the bottom hole in the T-plate. To do this, drill a 5.5mm hole in the correct place in the license
plate plate (D in the image below). Use the last M5 screw, nut and washer provided to attach. Hold the screw with an Allen
key and tighten the nuts to 5 Nm.
The license plate holder is designed and manufactured exclusively for mounting the license plate. Therefore,
Attention!
never use additional plates or brackets. The additional weight and dimensions can cause damage.
Attention!
The distance between the two indicators (lenses) must be at least 180 mm. This distance must be adjusted
because the indicator holders are adjustable in width. Tighten the M4 x 16 screws to 3 Nm.
Attention
: All parts and connections removed from the motorcycle must be reassembled in accordance with the vehicle
manufacturer's instructions. Unless otherwise specified, secure all threads with threadlocker. If not specified by the
manufacturer, all screws and nuts must be tightened in accordance with DIN / ISO. After assembly, ensure that all previously
24
Reassemble all original parts.
removed parts and connections have been reassembled correctly.
Step 16:
Publicité
