Publicité
Step 14:
Attention! :
The license plate plate (2 in the image below) must later be mounted so that it rests on the top of the base plate
(1 in the image below).
Attention! :
There must be a maximum of 1 mm between the reflector and the license plate. The reflector must sit as close
to the license plate as possible without touching it.
To mount the T-plate with reflector in the right place on the base plate, we need dimension A (A in the image below).
Dimension A is the height of the license plate plate + maximum 1 mm. Then mount the T-plate with reflector to dimension A,
measured from the top of the base plate (1 in the image below) to the top of the reflector. To do this, use the supplied M5
screws, nuts and washers (B in the image below). Hold the screw with an Allen key and tighten the nuts to 5 Nm.
23
Publicité
