To install the license plate holder you need the following tools:
• Phillips screwdriver PZ2
• Allen key set
• Torque wrench
• Ratchet and socket wrench set (7mm, 8 mm, 10 mm)
• Crimping pliers for cable lugs if cable lugs are included.
• Hot air gun for solder connectors if solder connectors are included.
• Tape measure
• 5.5mm drill and drill
15
Step 1:
First remove the passenger seat, then the bench seat.
As seen in the photos below.
Make sure that all parts in the parts list
are present and not damaged.
Scope of delivery:
1: Pre-assembled license plate holder with
indicator holder for original indicators.2:
Spacer plates
3: Indicator holder for mini indicators
4: T-plate
5: three screws, nut and washers for T-plate
6: two cable ties
7: two cable lugs