Publicité
AF-Manual-Plancha-UFESA PV2600 GlidePro.pdf
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the
plate. The resin filter is permanent and does not need replacing.
Please note:
Use tap water only. Distilled and/demineralized water makes the "Zero-Calc", anti-calc system
ineffective by altering its physicochemical characteristics.
TROUBLE SHOOTING
Problem
Soleplate (9) is not heating even
through iron is turned on.
C
M
Y
Steam does not come out
CM
MY
CY
CMY
K
Shot of steam / vertical ironing
function does not work
22
22
14/6/21
Possible cause
Connection problem
Temperature control (7) is at "MIN"
position
Not enough water in the tank.
Steam regulator (3) is selected in
non-steam position.
Selected temperature is lower than
that specified to use with steam.
Iron is not hot enough.
Selected temperature is lower than
that specified to use with steam.
13:35
Solution
Check main power supply cable
plug and outlet.
Turn to a higher position, if
compatible with the fabric.
Fill the water tank.
Set the steam regulator between
positions of minimum steam and
maximum steam.
Set to a higher temperature, if
compatible with the fabric.
Set a suitable temperature and wait
until the pilot light (10) goes out.
Set a higher temperature, if
compatible with the fabric.
Publicité
