Publicité
7. Check Connections
Open the water supply valve and check each
connection for leaks. If any leaks occur, turn
off the water supply valve and re-connect the
leaking components.
8. Connect the Power
Plug in the power cord. Ensure the power
indicator is lit; if not, press the reset button.
When the power light is on, the toilet will
initiate its diagnostic sequence. Lights
activate, the cleaning nozzle extends, the
motor starts, and water flows through the
system. When the light turns off, the self-
diagnostic process is finished.
9. Install the Remote
Wall Anchor
Remote Bracket
1.
Drill two 6mm holes on the wall that line up with the remote bracket.
2.
Install the wall anchors in the newly drilled holes.
3.
Place the remote bracket over the wall anchors.
4.
Use the provided screws to attach the remote control bracket to the wall.
5.
Place the remote control on the bracket.
16
PRODUCT INSTALLATION
Screws
Remote Control
Reconnecting Your Remote Control
When first installing, the remote control will already be paired
with the bidet. In the event the two become disconnected,
please reconnect using the following instructions:
a.
Unplug your bidet. Press and hold the stop button on
the remote until the level indicators flicker.
b.
Place the remote control close to the bidet and plug
it back in.
c.
The level indicators should stop flickering.
All level indicators should light up red (normal).
PRODUCT INSTALLATION
17
Publicité
