Publicité
Additional Warnings & Safety Precautions
•
Do not use the heated seat or warm dryer
temperature for an extended amount of time.
Extended use may result in burns.
•
Do not mix new and old batteries.
•
While using this product, make sure that
the skin is in contact with the seat sensor
area. Otherwise, product may not operate
correctly. Children and smaller individuals
may have trouble staying in contact with
sensor area.
•
Do not use your toilet hose. Use the one
provided with your product Anything else
connected to the older hose may need to
be replaced. Risk of water leakage and/or
property loss/damage.
•
In case of sudden power failure, remove
the power plug and close the water shutoff
valve to prevent water leakage. Risk of water
leakage and/or property loss/damage.
•
Avoid direct sunlight or heat.
Risk of product discoloration.
•
When the filter is being replaced, be sure to
close the water supply angle valve. When the
filter is being installed, be sure to fasten it
securely. Risk of water leak.
•
Pull out the power plug when the product is in
disuse for an extended amount of time. Make
sure to shut off the water and remove the
water inside the product. Risk of fire, leaks,
and product damage.
•
When storing or transporting in cold climate,
make sure to remove all water from the unit.
Product may crack and other damages may
occur due to freezing water. Risk of fire, leaks,
and product damage.
•
Do not pull, damage, bend, twist, stretch, roll,
bundle, clamp, or squeeze the power cable.
Do not place anything on the power cable.
Risk of fire and/or electric shock.
•
This product is not a toy. Advise children not
to play with product. Risk of injury.
20
MAINTENANCE
•
Do not install the product in a humid
environment or a soak room. Do not spray or
soak this product with any form of liquid to
prevent any damage to the product. Risk of
fire and/or electric shock.
•
Regularly pull out the power plug and wipe
off any dust on the power plug using a clean
dry cloth. Risk of fire.
•
Avoid direct sunlight or heat.
Risk of product discoloration.
TROUBLESHOOTING GUIDE
Experiencing Issues with Your Product?
If you experience any issues, please consult the troubleshooting guide below.
If the problem persists, contact Bio Bidet support at 847.458.2334 or email us
at support@biobidet.com.
Problem
Cause
•
Check if the power cord is loose.
Power/Stop is
•
Check if the product is powering
not working
on.
•
Check if the water supply.
•
No water is in
Check if the water
the nozzle.
inlet filter is blocked.
•
Check if the hoses are kinked
•
Check the water pressure
The water
settings.
pressure is too
low.
•
Check if the inlet filter is blocked.
Unusual water
•
flow from the
Abnormal operation
nozzle.
The water
•
temperature
Check the water temperature
is not warm
settings.
enough.
MAINTENANCE
Solution
•
Check the circuit
•
Press "Power/Stop"
button.
•
Restore the water
supply.
•
Open the angle valve.
•
Clean the filter mesh or
change water filter.
•
The inlet pipe must be
straight.
•
Increase the water
pressure settings.
•
Clean the filter mesh or
change the water filter.
•
Gently clean the nozzle,
then unplug the unit
for one minute before
plugging it back in.
•
Increase the water
temperature settings.
21
Publicité
