Publicité
STEP TWO: Installing the Door Edge Guards
2a
CUT OUT PAPER TEMPLATES ON PAGES 4 & 5. FIT THE NOTCH OF THE
TEMPLATE AROUND DOOR HANDLE. ALIGN TAB FLUSH WITH DOOR
EDGE. TAPE PAPER TEMPLATE TO DOOR.
2b
2c
CONTINUE WITH FIRM TAPPING MOVING UPWARD BETWEEN
STRIKE POINTS #1 & 4 AT ½ INCH INTERVALS.
PART NUMBER:
SOA801P000xx
START !!
HOLDING DOOR EDGE GUARD IN PROPER ALIGNMENT WITH ONE HAND,
DIRECTLY & DELIBERATELY PERFORM INITIAL STRIKE AT STRIKE POINT #1.
DATE:
ISSUE:
06-23-15
REV -
ALIGN TOP EDGE OF DOOR EDGE GUARD WITH
LOWER EDGE OF TEMPLATE ALIGNMENT NOTCH.
ENSURE MALLET HEAD IS
PERPENDICULAR TO THE
EDGE OF THE DOOR.
HOLD MALLET AS SHOWN.
~½"
VISUALLY ENSURE DOOR EDGE GUARD IS FULLY
ENGAGED, THEN START BACK AT STRIKING POINT #1
TAPPING DOWNWARD ENTIRE LENGTH OF DOOR EDGE
SUBARU OF AMERICA
ALIGN
USE SOFT SIDE OF
RUBBER MALLET
ONLY
GUARD.
~½"
PAGE
2/5
Publicité
