hergom C-11 Instructions D'installation, De Service Et D'entretien page 15

1. PRESENTATIÓN
2. INSTALLATION
1
2
3
IMPORTANT! All local regulations, including those that
refer to national or European norms, must be complied
with when the appliance is installed.
protect the hood assembly from the heat, the following
recommendations must be followed
1-Tubo chimenea
2-Rejillas aire caliente
3-Rejillas aire frío
protect the masonry hood from the heat, remember the
4-salida convención
forzada
following compulsory points:
4
1 C-11
1. Cast iron chimney
2. Sheet metal fairing with
2
3. Frente de chapa
3
4. Flue regulator bar
4
NOTE. When any kind of insulation is installed to
NOTE. When any type of insulation is installed to
1. The insulation should never be in contact with
the cast iron coating of the appliance. This
would prevent the heat from the cast iron from
being released to the atmosphere and hence
the subsequent breakage of the part.
There should be a minimum clearance
2.
between the cast iron and the insulation (this
distance is determined at the factory, using
the protruding length of the M10.
air outlets