Publicité
3.3. Assembling
1) Place the ground cloth in the
chosen location.
pump on the socket .
3-4 minutes. Ensure that the spa is
located in the back of the pump unit.
13) Fill water to 5cm height in the Spa.
ground cloth.
then screw the cartridge onto the lower
suction connection joint.
14) Lay out the Spa base and make
sure no wrinkles , then fill the water to
the recommended water level.
10
spa.
6) Connect the pump unit then press
9) Connect the unit pump to the spa
using the 3 connectors to screw.
Ensure the icons on the pump and the
spa match up
12) Ensure that the drain caps are
the spa
Publicité
