Publicité
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cy-
cle.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe
quilt cover
man's work shirt
man's pyjamas
sheet
tablecloth
man's shirt
night dress
pillow case
towelling towel
blouse
ladies' briefs
men's underpants
napkin
tea cloth
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Dry Plus
(Drogen Plus) and the Anticrease
(Anti-kreuk) buttons. Hold down un-
til one of the symbols go into view
on the display:
–
cm
–
300-600 μS/cm
–
1200 g
μS/cm
3. Push the Start Pause button again
700 g
and again until you set necessary
600 g
level.
500 g
4. To memorise the setting push at the
same time the Dry Plus (Drogen
500 g
Plus) and the Anticrease (Anti-kreuk)
250 g
buttons.
200 g
WATER CONTAINER FULL —
200 g
INDICATION
200 g
By default the indication LED is always
200 g
on. It comes into the view at the end of
100 g
the cycle or when the water container is
full. When you use an external equip-
100 g
ment to drain the container, the LED
100 g
can be off.
To activate or deactivate the indication:
100 g
1. Turn the programme dial to availa-
100 g
ble programme.
2. Push at the same time the Dry Plus
(Drogen Plus) and Buzzer (Zoemer)
buttons and hold down until you
see the correct setting:
– the LED is off and the symbol
LED is permanently off
– the LED is on and the symbol
LED is activated
ENGLISH
low conductivity <300 μS/
moderate conductivity
high conductivity >600
goes into the view - The
goes into the view - The
39
Publicité
