Publicité
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment will be affected and
may cause a malfunction. Once the appliance is placed in its final location, adjust the
leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm
water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing them.
Reversible door
The side to which the refrigerator door opens can be altered on the right side to the left, if the place of
installation so requires.
Ensure the appliance is unplugged and empty before starting.
CAUTION: Two people are required to carry this out to avoid possible damage or injury.
1. Keep the glass door closed during removal and fitting of the hinges.
2. Remove the plastic rivet (1) and top hinge cover (2) on the right side gently with a screwdriver to
expose the fixing screws.
3. Remove the top hinge screws (3) and the hinge bracket (4) on the right side (remember to hold the
glass door in place when undoing these screws).
4. Remove the glass door, then remove the plastic plug (5), and place safely aside.
5. Carefully lean the chiller backwards to an angle of approximately 60° to allow access to the bottom
hinge screws and feet. Ensure the appliance will not slip or move.
6. Remove the bottom hinge screws (7) and hinge bracket (6) on the right side.
7. Remove top hinge cover (2) and bottom foot (8) on the left side.
8. Fit top hinge cover (2) and bottom foot (8) on the right side.
21
Publicité
