Publicité
If the machine accidentally falls,it will stop and
the blade will fully stop after a few seconds. The
machine will then locks OFF.
9.4
STOP THE MACHINE
1.
Release the trigger to stop the machine.
9.5
TURN THE REAR HANDLE
You can use the rotating button to adjust the rear
handle to different positions to cut the hedges easier.
1.
Pull the rotating button and turn the rear handle.
2.
Release the rotating button until it locks into
position.
10
MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the
plastic housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
10.1
CLEAN THE MACHINE
WARNING
Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
English
NOTE
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
10.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades,
lubricate them carefully after each work session:
• Do not oil the blade while the hedge trimmer is
running.
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to
remove more dirt.
• Use a light layer of oil to lubricate the blades along
the top edge of the blade.
We recommend to use the non-pollutant type oil.
11
STORE THE MACHINE
Clean the machine before storage.
1.
Remove the battery pack.
2.
Let the motor cool.
3.
Check that there are no loose or damaged
components. If it is necessary, replace the
damaged components, tighten screws and bolts,
or speak to a person of an approved service
center.
4.
Store the machine in a cool and dry location.
9
NOTE
NOTE
EN
Publicité
