Publicité
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Power limitation
Power limitation defines how much power is
used by the hob in total, within the limits of
the house installation fuses.
The hob is set to its highest possible power
level by default.
To decrease or increase the power level:
1. Enter the menu: press and hold
seconds. Then, press and hold
2. Press
on the front timer until
appears.
3. Press
/
on the front timer to set the
power level.
4. Press
to exit.
Power levels
6. DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Activating and deactivating
Press and hold
to activate or deactivate
the hob.
6.2 Pot detection
This feature indicates the presence of
cookware on the hob and deactivates the
cooking zones if no cookware is detected
during a cooking session.
If you put cookware on a cooking zone before
you select a heat setting, the indicator above
0 on the control bar appears.
If you remove cookware from an activated
cooking zone and set it aside temporarily, the
indicators above the corresponding control
bar will start blinking. If you do not place the
100
ENGLISH
Refer to "Technical data" chapter.
CAUTION!
Make sure that the selected power fits
the house installation fuses.
CAUTION!
If the power level is lower than or equal
to 2000 W you cannot activate
SenseBoil®.
• P73 — 7350 W
• P15 — 1500 W
for 3
• P20 — 2000 W
• P25 — 2500 W
.
• P30 — 3000 W
• P35 — 3500 W
• P40 — 4000 W
• P45 — 4500 W
• P50 — 5000 W
• P60 — 6000 W
cookware back on the activated cooking zone
within 120 seconds, the cooking zone will
automatically deactivate.
To resume cooking, make sure to put the
cookware back on the cooking zones within
the indicated timeout.
6.3 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones adapt
to the dimension of the bottom of the
cookware automatically.
You can cook with large cookware placed on
two cooking zones at the same time using
Bridge function. The cookware must cover
the centres of both zones but not go beyond
the area marking. If the cookware is located
between the two centres, Bridge function will
not be activated.
Publicité
