Publicité
1. Turn on:
Plug in the heater. After "BI" voice, the heater enter into standby mode and show
on display. Press
temperature.
Factory default state:
Free mode: temperature setting is 22℃.
Day: Monday (1). Time: 12:00 AM (00:00).
Open window function: Off.
Timer: Off.
2. Week and time setting
Before using this appliance, you must set the week and time. Follow the below steps to do
this:
Hold
for three seconds. The display will show
Press
or
. The display will show
Press
or
to select between 1-7 (Monday-Sunday).
Press
to confirm day setting and enter time setting. The display will show
Press
or
button to set the hour.
Press
to confirm hour setting and enter minute setting. The display will show
flash.
Press
or
button to set the minute.
Press
to confirm all settings.
Note: If the power supply is cut off, the week and time will reset to the factory default
settings. The other settings will remain the same as before the power supply was cut
off. To ensure that your heater runs correctly, reset the week and time after a power
cut.
3. Heating mode
The heater has four modes:
Press
to cycle through the modes in this order: Fr→P1→P2→AF→Fr
Free mode: Temperature can be set between 5-35℃ by pressing
Weekly programme:
Note that if week and time settings are not finished, the first time you enter P1/P2 mode,
you will be requested to set the week and time first.
P1: The programme cannot be modified. If you enter P1, every day will run the default
setting as shown below.
button to turn on the heater, and display show the desired
(Monday) and flash.
1. Free mode (Fr)
2. Weekly programme (P1)
3. Weekly programme (P2)
4. Anti-frost mode (AF)
and flash.
6
icon
and flash.
and
or
.
Publicité
