Publicité
NO.
Description
1
Screw(M4*6)
Drill dimension
2
paper
Plastic
3
expansion tube
Expansion
4
screw(ST4*40)
1. As shown in picture (1), fasten four hook racks with eight screws (M*6).
2. As shown in picture (2), ensure there is at least 30cm of space between the heater
and other objects, such as floors and walls.
3. As shown in picture (3), use drill dimension paper to drill two top holes (Φ8) on the
wall, then put the plastic expansion tube into the holes and fasten the screws
(ST4*40) in the holes.
4. As shown in picture (4), hang the top two racks onto the expansion screws (ST4*40).
Mark the two bottom hook racks' position on the wall and take away the heater. Drill
two bottom holes (Φ8) on the wall, then place the plastic expansion tube into the
holes.
5. As shown in picture (5), hang the heater on the wall and put the expansion screws
(ST4*40) into the bottom two holes.
For Stand
1. Place the foot at the bottom of the body and make sure it fits properly.
2. Use eight screws (M4*10) to fasten both feet securely in place.
Parts list
Quantity
Note
Used for Wall
8
mounted
Used for Wall
1
mounted
Used for Wall
4
mounted
Used for Wall
4
mounted
NO.
Description
5
Screw(M4*10)
foot
6
Instruction
7
manual
Remote
8
controller
4
Quantity
Note
Used for
8
stand
Used for
2
stand
1
/
1
/
Publicité
