Publicité
Manual programming (DLX-500)
Press the DLX programming button for 1 sec. and an acoustic signal will be heard. The DLX will enter standard programming.
Every time a proximity element is programmed, the DLX will issue an acoustic signal for 0.5 sec. After 10 seconds without pro-
gramming, the DLX will exit programming mode, issuing two acoustic signals of 1 sec.
Total reset
In programming mode, the programming button is held down and the "MR" reset jumper is bridged for 3 secs. The receiver
will issue 10 short acoustic warning signals followed by others at a faster pace to indicate that the operation has been suc-
cessful. The receiver is now in programming mode.
After 10 seconds without programming or quickly pressing the programming button, the receiver will exit programming mode,
issuing two acoustic signals of 1 sec.
jcmtechnologies
4
Publicité
