Publicité
Technical characteristics
Frequency
Coding
Memory
Number of channels
Supply
Access control output
Standby/Op. consumption
Op. temperature
Watertightness
Size
Installation and connections
Attach the rear part of the housing to the wall using the plugs and screws supplied. Pass the cables through the bottom of the
equipment. Connect the power cables to the terminals marked in the mother board, as indicated. Fix the equipment front to
the rear part using the screws supplied.
Operating
The pilot lights are activated every 5 seconds to indicate the correct supply of power to the equipment. Upon receiving a
code, the receiver checks whether it is in its memory, activating the corresponding relay. The relay activation mode is selec-
ted in either impulse or ON/OFF using the programming tool (only with relay 1).
Programming
Manual programming (DLX-500R / DLX-IP65-R)
Press the receiver programming button for 1 sec. and an acoustic signal will be heard. The receiver will enter programming
(see table). If the receiver programming button is held pressed down, the receiver will pass cyclically from one configuration
to the next. Once the programming configuration for the transmitter to be registered has been chosen, send the code to be
programmed by pressing the transmitter. Every time a transmitter is programmed, the receiver will issue an acoustic signal
for 0.5 sec. After 10 seconds without programming or pressing the first two transmitter buttons, the receiver will exit pro-
gramming mode, issuing two acoustic signals of 1 sec. If upon programming a transmitter the receiver memory is full, it will
issue 7 acoustic signals of 0.5 sec. and exit programming.
Configuration of transmitter programming in the receiver
Standard programming(default option, the receiver always is configured in multichannel)
The relay is activated 1st relay by channel 1 (3rd relay by channel 1)
Special programming
Press the transmitter channel to activate the relay 1 on the receiver
N.B.: Each transmitter can be configured independently on the receiver.
DLX-500
---
High security rolling code
IP44
127x70x52mm
jcmtechnologies
3
DLX-500R
868,35MHz
500 codes
1 channel
12V ac/dc ±10%
BUS-L
30mA / 90mA
-20ºC to +55ºC
DLX-IP65-R
IP65
82x190x40mm
Led R1
Flashing
ON
Publicité
